|
Re: Body Side Protectors (Honda) Install Summary
I installed the body side protectors following Truckin's instructions (Thanks!) but included the use of a string to establish the top edge of the molding. Established the marks at front of front door, between the doors and back of the back door. Then attached the string using electritions tape. Even though I gave it lots of tension, there was still a slight sag in the middle. Small piece of tape between the doors fixed that issue.
Only mistake I made was that I did not have the front door pieces as far back as instructed because could not see edge and hold the piece at the same time.
__________________
Babe has a Roof Rack, Fender Flares, Side Molding, Hitch, Running Boards, Air Deflector, IPod connection,
and Line of Fire LEDs on the tail! 
|