Quote:
Originally Posted by Chris C
"Brown" just dropped off my Running Board for the Ridge. I've downloaded the destructions from H and A and have just realized I don't own a few of the tools required for installation. DRAT! I'm not going to ever need those tools again, so I don't need the worlds best or most expensive.
The tools I need are a Torque wrench, Rivenut special tool, Insert tool, and a 27mm Hex wrench. So where should I go..............Harbor Freight Tools?
|
Harbor Freight is a good place to get the 27mm wrench if your not going to use it often.
You shouldn't need a torque wrench, I would think, to install running boards, even though the directions prolly give torque specs.
There is a thread here somewhere that shows how to make or substitute the Rivenut special tool.
Good luck in your install - they are always fun and gratifying
{Edit} Ahh - found it here:
$1.87 Rivet nut tool for step/running boards.