Anyone used the Drawtite Hitch?

I ordered one today because I liked the round bar look. Also got the wiring harness from them....
Any thoughts? :)

Let us know how the install goes and what your thoughts are after getting it installed.

I was about to order it, but passed due to the delay in the converter. All in all, using the Draw-Tite the way it should be used (with the Modulite), it would have saved me $100, which wasn't enough to sway me from the factory hitch (which is also a round tube hitch).

I'm sure it will be a great product. Let us know how the installation goes.

I have it and I used the factory harness. I saved 275.00, if I had gone with the factory it would have cost me 886.00. I like it and it works great.

JMT,

I was thinking of going this route. How did you mount the factory connectors (where you plug in the trailer wiring)? The installation drawings show that the factory harness bolts to the hitch itself. I would assume Drawtite doesn't have the same mounting location for this.

The $100 was parts only. I would have done my own installation either way. I have the same questions as the last poster. How did your installer mount the factory harness to the Draw-Tite hitch? A picture would be great. Thanks :)