Bob79
12-23-2005, 04:50 PM
I too have noticed like others that the dash area makes a squeak or rubbing together of plastic noise. And mine was coming from the driver's side by the speaker area in the corner. Sometimes the passenger side will do the same thing, and it gets worse in the colder weather (like when 32 or colder).
I noticed that if I wedged my hand in between the dash and the a-pillar (I have the gray interior truck) where that panel is lighter colored gray than the dash there was no more noise. This was because it pushed the a-pillar plastic back away from speaker cover and the rest of the dash next to the speaker cover than comes into contact with the a-pillar.
So I took some ear plugs (Mack's) that are made of that spongy material that bounces back after you smash it and I cut it in half long ways. Now you have a long flat surface, then I took a black magic marker and colored it in on the flat surface, and around the edges. Now take that half an ear plug and flatten it good against the counter or ground (flatten it on the side so that the colored area gets very thin), then you shove it in that small gap between the a-pillar and that dash/speaker cover area. If you wedge your hand there first it helps to spread it open a little, and you put it in so that the flat edge you colored faces up. I also used a flat-head screwdriver to help push it into place. This pushes the panels apart a little so they don't have any more room to rub and make noise.
Now my steering wheel that creaks.....thats another problem:mad:
I noticed that if I wedged my hand in between the dash and the a-pillar (I have the gray interior truck) where that panel is lighter colored gray than the dash there was no more noise. This was because it pushed the a-pillar plastic back away from speaker cover and the rest of the dash next to the speaker cover than comes into contact with the a-pillar.
So I took some ear plugs (Mack's) that are made of that spongy material that bounces back after you smash it and I cut it in half long ways. Now you have a long flat surface, then I took a black magic marker and colored it in on the flat surface, and around the edges. Now take that half an ear plug and flatten it good against the counter or ground (flatten it on the side so that the colored area gets very thin), then you shove it in that small gap between the a-pillar and that dash/speaker cover area. If you wedge your hand there first it helps to spread it open a little, and you put it in so that the flat edge you colored faces up. I also used a flat-head screwdriver to help push it into place. This pushes the panels apart a little so they don't have any more room to rub and make noise.
Now my steering wheel that creaks.....thats another problem:mad: