Joeyo
01-19-2006, 03:13 PM
KTC TRIM TOOL
I have just ordered the rear back-up sensors along with the fog lights and towing bar/harness. After reading the instructions for the rear sensors you have to remove the “outside trim around the upper 3rd rear brake light.” The instructions refer to a KTC trim tool; some people said I could use a small flat screw driver, but I’m not sure whether this would work effectively. After looking around on the web, I believe I have located one of these trim kits if anyone is interested.
Here is their web link. I have order one and will tell everyone how it works after I do the install.
http://thetoolnetwork.com/panel_popper_kit_by_ktc_tool_company.html (http://thetoolnetwork.com/panel_popper_kit_by_ktc_tool_company.html)
JoeyO
I have just ordered the rear back-up sensors along with the fog lights and towing bar/harness. After reading the instructions for the rear sensors you have to remove the “outside trim around the upper 3rd rear brake light.” The instructions refer to a KTC trim tool; some people said I could use a small flat screw driver, but I’m not sure whether this would work effectively. After looking around on the web, I believe I have located one of these trim kits if anyone is interested.
Here is their web link. I have order one and will tell everyone how it works after I do the install.
http://thetoolnetwork.com/panel_popper_kit_by_ktc_tool_company.html (http://thetoolnetwork.com/panel_popper_kit_by_ktc_tool_company.html)
JoeyO