Toggle Switches

[Engyo]

Originally Posted by dj addicted

there should be 3 pins on the back. One is ground, one is power for the actual fog lights, the other is power for the light when it is pushed in. A standard multimeter should be able to locate which is which.

Well, the switch the dealer sold me has 5 pins. I have the diagram from HandA but there are no markings to determine which pin is which, and without power to the appropriate pins, it isn't closing contacts or anything. Probably some solid-state board inside.............

[HCM_Ridge]

Originally Posted by Engyo

Well, the switch the dealer sold me has 5 pins. I have the diagram from HandA but there are no markings to determine which pin is which, and without power to the appropriate pins, it isn't closing contacts or anything. Probably some solid-state board inside.............

Here is the listing from Alldata for the pins:

#1 - to Ground
#2 - Fog Light Control - goes through Fog Light relay to Fuse 6 (Under Hood Fuse Box)
#3 - Illumination Positive circuit (switch internal lighting)
#4 - Illumination Negative circuit (switch internal lighting)
#5 - Fuse 6 (Under Hood Fuse Box) - Controls green 'Active' light on switch

The Factory harness taps into the Cruise control connector to power #1, 3 & 4. Interestingly, Alldata describes this as a Fog/Driving light switch... looks like you could follow the instructions for the fogs lights but just relocae the wire in thefuse bos to get driving/high beams only. Perhaps both could work on the same switch?