Sound deadening - How much?

clsmith · #1 (**permalink**) 04-16-2008, 09:19 AM

I'm in the process of gathering the components for a new audio install. I don't plan on going "all out" but I'd like to use RAAMmat to do the back of the cab and all 4 doors (inner and outer skins).

If anyone has worked with it before, will 1 roll be enough (15in.x50ft.)?

shovelhd · #2 (**permalink**) 04-16-2008, 01:08 PM

I used twice that amount.

clsmith · #3 (**permalink**) 04-16-2008, 02:36 PM

Quote:

Originally Posted by shovelhd

I used twice that amount.

Did you do more of the cab (i.e. entire floor, roof etc.)?

CrackMonkE · #4 (**permalink**) 04-16-2008, 02:58 PM

I did the floor (driver/passenger footwells back), the doors (inner and outer skin) and rear wall with 112 sq ft. If you are just going to do the doors and rear wall, probably about 70sq ft of material is needed.

shovelhd · #5 (**permalink**) 04-16-2008, 06:41 PM

I did the floor from the rear seat latch back, doors, rear bulkhead, and the seat bottoms with 120 sq. ft.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Engine noise on idle	Shutterbug	Problems & Issues	13	06-26-2008 01:03 PM
The sound of the Ridge...A question	Fastmax32168	Under The Hood / Performance	8	05-28-2007 08:50 PM
Sound Deadening Material	alanderego	Mobile Electronics	29	11-04-2006 10:42 PM
Sirius or XM Satellite Radio?	steveberger	Mobile Electronics	17	08-22-2006 10:52 PM
High Frequency Fidelity of Sound System	Desert Ridge	Mobile Electronics	3	08-04-2005 09:55 PM