Honda Ridgeline Owners Club Forums banner

Lug Nut Size?

5K views 4 replies 4 participants last post by  swampler 
#1 ·
Anyone know it, I want to buy locking lugs and dont want to pay dealer prices so I am looking at generic ones.
 
#3 ·
Also, make sure they are the right type, some lugs are beveled, others are not (meaning how it fits the rim) so height and thread size are not the only factor.

As an example, most older type steel rims accepted beveled lugs, where the lug and rim meet.

I believe that most alum. rims have lugs that have a flat botton and a wide washer at top, which in effect the rims "sits" on top of as the lug shaft goes through the rim. I have seen various type of lugs suited to different types of rims, both steel and alum.

I hope this makes sense.

RidgeLI
 
#4 ·
Lug nut thread is 10 mm. I strongly suggest you take Ridge LI's advice as far as the type of nut to install for your oem or aftermarket mag wheels.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top