Honda Ridgeline Owners Club Forums banner

lug size

3K views 3 replies 2 participants last post by  Andy-Montreal 
#1 ·
I am currently in the middle of a wheel swap and the lugs provided by my seller were to small to fit the the factory wheel studs.
The lugs provided were size 12x1.50 but I think I need 14x1.50.

Does anyone know the correct lugs size for my 07 RTS?

Thanks, Joe.
 
#3 ·
Thank you Andy, after 2 hours putting the TPMS in each tire and NOT being able to put the wheels on, I was a tad bit upset.
 
#4 ·
I understand on the frustration bit....especially after waiting so long to get everything together and onto the truck. I also opted for the longer shank spline nuts on my wheels so that my socket would fit easier.

Make sure that your new spline nuts correctly fit your mag wheel and that the base part (usually conical on aftermarket wheels) is the right angle. A set of McGard aftermarket wheel lock nuts will protect your investment from the bad guys.:D
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top