Honda Ridgeline Owners Club Forums banner

power

  1. Second Generation Ridgeline (2G 2017+)
    Page 48 of the 2017 Ridgeline's manual. Power folding mirrors *if so equipped. I do not see folding mirrors as an option anywhere.....? I am already irritated that the specs state 'locking tailgate'- which is not true. At over $40K - folding mirrors are expected - as is a locking tailgate. I...
  2. 1G Problems & Issues
    I replaced my battery after noticing a decent amount of corrosion on the + terminal and it was having a hard time turning over (was also 4 years old) since then I have this strange issue where sometimes, after driving it and it sitting for a while, the car wont start. It sunder like the starter...
  3. 1G Mobile Electronics
    How to install resistor on rear camera power line This regards a previous post regarding a possible power surge when power is initially turned on for a rear camera. This could decrease the life expectancy of the camera. It was recommended to add a 8.2 ohm5% 1/4 resistor. The resistor I...
  4. 1G Mobile Electronics
    I currently have my amp's remote wire hooked up to ignition so when key is turned it powers up, it works great but I share this car with my family and they do not enjoy the base of my two rockford fosgate p2d4-15's, so as of now I have been unplugging RCA cables from amp every time I get out of...
  5. 1G Problems & Issues
    I have a 2006 RTL. I recently developed a problem with the power locks. The locks will only lock manually. They will not lock with the keyless entry, or with the power lock button (either the driver's side or the passenger's side). They also stopped locking when I take the vehicle out of...
  6. Racks, Hitches & Towing
    In my 07 RTX, the ignition needs to be in the II position to power the Battery + pin (1 o'clock) in the 7-pin connector. Using a 7-pin plug, I run a cord to power my Remote Control Car chargers. It sucks that I have to have the ignition in that position, because it powers the dash, fuel pump...
  7. 1G Mods, Installs and How-To's
    Hello all, Can anyone recommend an easy way to add an auxiliary 12V DC power outlet to the inside of the glove box? I noticed near the top of the inside of the glove box there is a wiring harness looking thing that I'm thinking could be plugged in to with the right mate? Thank you.
Top