Honda Ridgeline Owners Club Forums banner
1 - 3 of 9 Posts

· Registered
Joined
·
239 Posts
Discussion Starter · #1 ·
Does anyone have the alignment specs for a lifted Ridgeline? Bought used Ridge and had to put struts and a front passenger side axle on it, it is lifted so if it needs a different spec for the alignment I would be appreciate it if anyone could share!
 

· Registered
Joined
·
239 Posts
Discussion Starter · #6 ·
Thanks guys. New tires should be here today. so hopefully get it in and get them mounted and get the truck aligned next week. The guy I bought the truck from ran different sized tires on the front and rear axle(245/70 on front and 265/70 on rear on aftermarket rims, been on stock wheels since I found out). Wish I would have caught that before we bought it.
 

· Registered
Joined
·
239 Posts
Discussion Starter · #8 ·
Bummer, not good.
Think of anything that you would look for to be a problem area after this? I believe very well might have been part of the reason the right front cv joint went out. Luckily he had just put these wheels and tires on and the tires are still prickly on the outside, hopefully we caught it soon enough. I cant believe any tire shop would install 2 different sized tires on any 4wd. I figure early spring I'll change the trans fluid along with vtm-4 and front diff. So far I've fixed a bunch of little odds and ends (drivers headlight was not seated in housing, xm radio was unplugged?, cabin filter was upside down, washer fluid reservoir was loose, new power steering pump o-ring, struts and axle) hoping this isn't a continuing trend. It's the Mrs. ride, I talked her into buying something a little cheaper instead of a 16 Pilot in the hopes she would save money and could buy a new pilot in a couple of years with cash. Beginning to think I should have just told her to get the Pilot........... after all it's her money! haha
 
1 - 3 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top