Honda Ridgeline Owners Club Forums banner

By Popular Demand, the $10 Electric Tailgate Lock

127731 Views 171 Replies 73 Participants Last post by  zannej
To those of you who asked for a write up on this long ago, I aplogize. I finally got around to taking pics of my creation tonight. You will not have to do any drilling into your RL. You use the stock holes that are already there. Here is how you make it.

First you will need an electric actuator. This is the one I used.

The price is $4.25.

Now, you will have to go down to Lowes or Home Depot or maybe in your garage and get a set of 3" T brackets.

The price $2.97

You will need to then take one of the T brackets and take off the top leg. I used a pair of pliers and just bent the leg back and forth until it came off. If you want to get fancy, you can use a hacksaw. I didn't.

You then bolt the end that had the predrilled hole to the center hole of the other intact T bracket left in the package. I put 1 little nut in between the 2 bracket parts to make a swivel with enough room to clear the locking mechanism. I then used 2 additional nuts on the end of the bolt that are forced together so that they don't move on the bolt shaft. Here is a pic of the assembled locking mechanism. If you bolt this together correctly, it is EXTREMELY strong.

See the little oddball hole I drilled in the intact bracket on the bottom right side to the upside down T? You will have to drill this as well to line up with the stock hole in the tailgate. You then bolt it down and check for fitment. I didn't line up the holes in the picture very well but you will get the idea when you see it in person. The leg of the intact T bracket has to go under the tailgate locking mechanism as shown in the picture below. Disregard the metal rod in the picture. We havent gotten that far yet.

OK, now you will need brackets to install the lock actuator. I used the metal strip that came with the lock actuator. I used the bend back and forth method to bust it into 2 parts. I then mounted each end to the actuator first and then bent them under as shown in the picture. The screws were included with the actuator.

The trickiest part of the entire install was bending the actuator rod so that it would operate the locking mechanism. This also comes with the actuator. If you look at the last picture, the rod runs under the actuator. I can't really explain it as well as you can see in the picture.

(Continued in next post)
See less See more
1 - 2 of 172 Posts
Chris, does this lock function similarly to the other locks? I.E. does it jam the lock? TIA for your reply.
ChrisM said:
The tailgate lock is wired into the door locking system. There used to be a PDF online of how to connect the wiring. That company has since gone out of business. The wires connect at the base of the B pillar inside the truck.

My tailgate lock locks the tailgate from being opened with either handle. You are correct in saying that my cargo is secure.

I'll see if I can find some info of how to connect the wire for you. No promises though.

I saw the instructions on the wiring. Check out this link. Enjoy. :cool:
  • Like
Reactions: 1
1 - 2 of 172 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.