Honda Ridgeline Owners Club Forums banner
1 - 1 of 4 Posts

· Registered
11 Posts
Discussion Starter · #1 ·
Hey guys

I noticed in the manual it gives levels for the rear diff and transfer case fluid levels when your doing a drain/fill.

Now, I dont think its going to be rocket science where I need to measure the EXACT amount stated there in order to get the proper fill level right? Conventionally you simply fill until you notice fluid starting to trickle out of the fill points. Im assuming those readings in the manual is the amount of fluid it takes to get to that point?

in general -can I disregard measuring and fill untill I notice fluid coming out?

thanks !
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.