[optimus29]

I need to remove my drivers side door, when installing new wires to door, took the black rubber from white retainer clip in cab off.. I've tried putting back on :frown:.. No luck

So what size sockets do I need? What's best way to approach this.. Can it be done bymeslf. I would obviously use a stand or jack to stabilize door?! Thanks I know I might of posted in wrong forum..

 

[Heli ATP]

The bolts on the door are 12mm. I remember having a problem with that as well but didn't remove the door. Here is a post on how some others handled it...

http://www.ridgelineownersclub.com/...onics/25240-rubber-boot-white-connectors.html

http://www.ridgelineownersclub.com/...how-run-new-speaker-wire-driver-s-door-2.html

 

[optimus29]

I've just started at bottom of grommet. Used lube to make it easier.. But poked hole in it by accident. Since this is main grommet that enters cab, I silicon around edges so hopefully all be dry... Did not wanna take door off