Honda Ridgeline Owners Club Forums banner

Need for lock on in bed invertor?

1124 Views 5 Replies 3 Participants Last post by  zroger73
Am I the only only one thinking about ways to lock up the invertor door on my RL when I get her?

A justified concern?
1 - 6 of 6 Posts
Worried that someone will charge their Dewalt while you're at the movies, potentially leaving you with a dead battery?
Or that someone will steal your charger that was in there?

I expect there's an interior switch to turn it on/off, so #1 probably isn't that likely.

Chip H.
I expect kids will screw with it... what happens if you stick a paper clip into the receptacle holes?

I was a very bad kid 40 years ago. :eek:
Worried that someone will charge their Dewalt while you're at the movies, potentially leaving you with a dead battery?
Or that someone will steal your charger that was in there?

I expect there's an interior switch to turn it on/off, so #1 probably isn't that likely.

Chip H.
I expect there's an interior switch to turn it on/off
More specifically, it will almost certainly only work while the ignition key is in the "on" position (and NOT in the "accessory" position - just like the 100-watt inverter on the first-generation Ridgeline) and quite possibly only if the engine is actually running. A 400-watt inverter that is 90% efficient will require about 37 amps at full load. A typical, 12-volt automotive battery is rated at 40 Ah, so it'd be "dead" (incapable of starting the vehicle) in less than one hour. Also, draining a battery that low even once takes months, if not years, off its life.

400 watts is enough for electronic devices and cordless tool chargers, but you won't be running any refrigerators, power tools, "hot plates", or heaters off of it.
Ya, I found the switch in a YouTube video.

Attachments

See less See more
I expect kids will screw with it... what happens if you stick a paper clip into the receptacle holes?
Like the 100-watt inverter in the first generation, it will instantly switch off until the cause of the current fault or overload condition is removed. Most inverters have internal over-current, over-temperature, and ground fault detection that will cause their output to immediately switch off. Most will automatically reset. Some will rest only after power is removed and re-applied. A few require a manual reset. With the amount of liability involved these days, you can rest assured it will be safe.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top