Honda Ridgeline Owners Club Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
I was rubbing my rear door weather strip molding down with some 303 and came across a problem with my rear door molding sagging at the bottom. Attached is a picture. Anyone with this problem? I took it back to my dealer, but I was having a delivered scratch on my rear bumper repaired, yes check it over ladies and gentelment on delivery! And they did not correct it, might have been overlooked, but I thought I would check to see if anyone else out here in Ridgeland had a similar issue. My saleslayer told me it might be designed that way?:mad:
 

Attachments

·
Premium Member
Joined
·
5,392 Posts
Could you post another pic that's pulled back a bit? It's hard to see what part of the door it's on.

No, it's NOT designed that way!
 

·
Registered
Joined
·
50 Posts
Discussion Starter #3
Back door, lower rear corners, both doors. Attached is a pull back from the right rear door. Front doors are fine.
 

Attachments

·
Premium Member
Joined
·
5,392 Posts
If it was designed to be that way, it would be the same on both sides. I can't believe they'd blow off your complaint like that. It's obviously not attached where it should be. Ours does not look like that.
 
1 - 4 of 4 Posts
Top