Honda Ridgeline Owners Club Forums banner
1 - 11 of 11 Posts

· Registered
Joined
·
224 Posts
Discussion Starter · #1 ·
Ok. Front and rear mud flaps were an easy install. However, on the rear flaps I came up with a dilemma. I did the install as instructed. But the rear most screw that is behind the flap goes no where. I put the clip on as instructed, and inserted the screw. But the hole in the rear quarter panel is too large for the screw to grab. What is anyone doing with this? Longer screw with washer and nut? :surprise: Tom :smile:
 

· Registered
Joined
·
235 Posts
Ok. Front and rear mud flaps were an easy install. However, on the rear flaps I came up with a dilemma. I did the install as instructed. But the rear most screw that is behind the flap goes no where. I put the clip on as instructed, and inserted the screw. But the hole in the rear quarter panel is too large for the screw to grab. What is anyone doing with this? Longer screw with washer and nut? :surprise: Tom :smile:
Are you missing the spring nut?

http://www.hondapartworld.com/image/data/2017 RIDGELINE/2017 INSTRUCTIONS/08P09-T6Z-100.pdf
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top