[Jbgreen10]

Ok. Front and rear mud flaps were an easy install. However, on the rear flaps I came up with a dilemma. I did the install as instructed. But the rear most screw that is behind the flap goes no where. I put the clip on as instructed, and inserted the screw. But the hole in the rear quarter panel is too large for the screw to grab. What is anyone doing with this? Longer screw with washer and nut? :surprise: Tom :smile:

Are you missing the spring nut?

http://www.hondapartworld.com/image/data/2017 RIDGELINE/2017 INSTRUCTIONS/08P09-T6Z-100.pdf

 

[Jbgreen10]

The splash guard tab goes on the inside...that's how the screw holds onto it.

I was pretty sure that was the issue too. Did the same thing myself, although briefly, when I installed mine.

 

[Jbgreen10]

some pics.

Refer to step 4 on page 3 and notice how the tab is on the inside and not visible.