[t_brush]

How do I remove the rear seat so I can take a look at the subwoofer? I could probably figure it out, but it'd be simplier just to ask

 

[Snapshot]

t_brush

In the installation of the backup camera it show how to remove the rear seat.


http://www.handa-accessories.com/ridgeline/backupcamera.pdf

 

[vertrkr]

The rear seat is heavy so use two people if you can. Also, the directions specify a torque of 25 ft lbs for the 6 bolts that hold the rear seat in. I think this is incorrect as the Service Manual states a 35 ft lb torque and must be re-installed in a certain sequence. When putting the rear seat back in install the bolts in this order. (1) center left (2) center right (3) left lower (4) right lower (5) left upper (6) right upper.

 

[csimo]

How do I remove the rear seat so I can take a look at the subwoofer? I could probably figure it out, but it'd be simplier just to ask

There's been pretty much info on the sub published here. What do you want to know?

From first hand experience I'll tell you that the rear seat is heavy and not easy to deal with. Not worth the effort of removing unless you have a plan of action.

 

[mr_reliable]

t_brush

In the installation of the backup camera it show how to remove the rear seat.


http://www.handa-accessories.com/ridgeline/backupcamera.pdf

Seeing as how this link is no longer valid, and this PDF is linked to like ten million times all over this forum, I've attached it to this post. Links go bad over time, folks...