Honda Ridgeline Owners Club Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
116 Posts
I've used JB Weld epoxy in a stripped nut...mix the two parts, use a toothpick or similar and smear it heavily over the stripped area. Take some WD-40, or better yet, some TriFlow and lube the bolt. Screw in loosely (do NOT tighten yet!) and let the epoxy set for at least a few hours. Overnight is best (park in sun if possible to heat the area, which accelerates the curing). Then tighten...done!

Aloha,
Keoni
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top