Honda Ridgeline Owners Club Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
96 Posts
Discussion Starter #1
Finally after three months I'm going to install my navi... I purchased a Kenwood DNX6140, and a Kenwood KSC-SW10 sub for my truck. This weekend is install time. We were reading the driections from Crutchfields and they talk about the speed sensor wire. Any input as to where we can find it? And one more question.. kind of... where did you put the stupid little antenna for the XM and navi? I hate those little black things. wonder if I could hook up the XM to the existing XM antenna? thanks for any input...
Jayne
 

·
Registered
Joined
·
4 Posts
Speed Sense wire is Blue/white ac signal At PCM,Connector A, Pin 29 The PCM is under the hood on passenger side. XM receiver is behind the rear passenger seat.
 

·
Registered
Joined
·
10,043 Posts
Kenwood HU's do not need or use the speed sensor wire. Crutchfield routinely gives out bad information.
 

·
Registered
Joined
·
96 Posts
Discussion Starter #4
Kenwood HU's do not need or use the speed sensor wire. Crutchfield routinely gives out bad information.
good to know. thanks shovelhd. Once it's installed I'll try to get some pics.
thanks again.
 
1 - 5 of 5 Posts
Top